If you'd like to set up 
repeats in MuseScore 4,

first open the "Repeats & jumps" palette.

If you can't see this palette, you’ll find 
it by clicking on the "Add palette" option

and pressing this "Add" button 
to move it to the main list.

Now you simply select the bar where 
you want the repeat ending to occur,

or you can select the 
desired bar line itself,

and then select the appropriate 
repeat symbol to add it.

I now want to specify that the 
repeat should begin on bar 2,

so I'll add the appropriate 
repeat symbol here as well.

Now if you press play, you'll see 
the playhead jumping back to bar 2

as it should do.

You can switch on and off 
the playback of repeats

by selecting this settings button 
and toggling the "Play repeats" option.

If you want to set volta brackets, 
often referred to as repeat endings,

you can also find these in
the "Repeats & Jumps" palette.

Using these, I can specify which bars 
are played and excluded on each repeat.

I'm going to place this first 
volta bracket before the repeat,

meaning that this bar will be played the 
first time around.

I'll now place a second volta bracket 
after the repeat marking.

This means that the second time around, the
playback will skip over the first volta bracket

and jump straight to the 
second volta bracket instead.

If you wish to extend a volta bracket,

it’s advisable to use the generic keyboard 
shortcut for extending a line:

holding Shift and pressing the Arrow key.

Another useful element in the "Repeats & Jumps" 
palette is this "Repeat last bar" symbol.

By adding this symbol to a bar, it will 
repeat the previous bar during playback.

Lastly, there are the 
Segno and Coda elements,

which are also found in the 
"Repeats & jumps" palette.

Let's start with the Segno element,
and add it to this bar.

And then let's tell the player to go 
back to that Segno marking

later in the score, by adding a Dal Segno
(or D.S for short) element here.

Now, if we want to add a Coda jump too, 
we can alter this setup.

Let's first place our Coda symbol 
on a bar near the end of the score.

Next, let's delete that Dal Segno element and 
replace it with the Dal Segno, al Coda element.

Lastly, let's add a To Coda element here.

Now the playback will 
follow the following logic:

Once it reaches the 
Dal Segno, al Coda element,

it will jump back to the bar with the 
Segno marking. From that point,

it will play through again, until it 
reaches the To Coda marking,

which tells it to jump to the bar 
marked with the Coda symbol.

If you liked this tutorial
and want to learn more about MuseScore,

be sure to subscribe to this channel.