[upbeat music]

It's time to dig in to
some fun features of Sprite Lab.

The first thing to do 
is to setup a Sprite.

To add a Sprite, you can use

the "make a new sprite" block.

This block lets you give

your Sprite a costume and a location.

If you want to change 
the Sprite's location,

you can click the pin
in the "location" block,

and then click where you want it to go.

You can change the size 
of your Sprites too.

To make a Sprite smaller,

you can use the "set size" block

and then type in a number 
that is less than 100.

If you have two or more Sprites

with the same costume,

this will change all of them at once.

Now, let's get the sprite moving

by using a behavior.

You can start by giving the Sprite

the "spinning right" behavior.

Once a behavior begins,

it will run over and over again forever,

or until you tell it to stop.

And that's all there is to it.

Now it's your turn.

[upbeat music fades away]