[upbeat music]
It's time to dig in to
some fun features of Sprite Lab.
The first thing to do
is to setup a Sprite.
To add a Sprite, you can use
the "make a new sprite" block.
This block lets you give
your Sprite a costume and a location.
If you want to change
the Sprite's location,
you can click the pin
in the "location" block,
and then click where you want it to go.
You can change the size
of your Sprites too.
To make a Sprite smaller,
you can use the "set size" block
and then type in a number
that is less than 100.
If you have two or more Sprites
with the same costume,
this will change all of them at once.
Now, let's get the sprite moving
by using a behavior.
You can start by giving the Sprite
the "spinning right" behavior.
Once a behavior begins,
it will run over and over again forever,
or until you tell it to stop.
And that's all there is to it.
Now it's your turn.
[upbeat music fades away]